The top right inside strake skin was not that different to the left. No surprise. Just careful fitting.

I decided to cut part of the leading edge rib template off so I could ‘flow’ the top down without trimming it to the exact size. Just in case I needed it, I made a template pic of each rib. I did the same thing before cutting on the other side too. I think if the leading edge itself is preserved it will be academic to make that last little curve in foam later.

More cutting and fitting these big pieces of foam.

Here’s the inside glassed and good for the next step.

I quite like the look of having something more like an aeroplane or airplane if you are from the USA. You can see the baffles (and rib BL23) on the left are ready for a proper trim.