After the cutout BID lining it was just a clean up then the .25″ 2024T3 piece is installed with micro. After that a .016″ shield with 5mt epoxy so the sheer web can be laid up without a huge hole! It will get plenty of real epoxy when that happens!

I couldn’t help myself and alodined it all. If its alloy it get alodine. If only to help the epoxy grab better and its good to know I’ve done what I can for corrosion protection.

Pic 2 shows the access hole done and the final pic the right wing from above. I decided to pull all this out of the jig and put the left wing in. I just want to get this done on both.

I might just have a look at the two wings side by side on the bench before moving on too. I want to check the angles of the big end block FC1 to ensure they are similar. That will be towards the end of the week the way its going.

Mid pieces ready to go

Cutouts done

Right wing sheer web view